Andersen 3SNEZR36BL Instalační příručka stáhnout pdf (Strana 7)

7

6. INSTALL RAIN CAP MOUNTING FLANGE, SCREW COVERS, AND WINDOW RETAINERS

Tools needed:

RIGHT HANDED - EXTERIOR VIEWS

In this step, you will install one of the

two rain cap mounting ﬂ anges provided.

Choose the rain cap mounting ﬂ ange

that best covers the gap present

above the rain cap.

Hook rain cap mounting ﬂ ange to

rain cap. (Figure 23)

While hooked, push up on rain cap

mounting ﬂ ange and use the 1/8”

drill bit to a drill hole in the mounting

surface through the holes in the

ﬂ ange. (Figure 24)

While pushing up on the rain cap

mounting ﬂ ange, fasten ﬂ ange to the

mounting surface with two #8 x 1”

screws. (Figure 24)

Starting with the rain cap screw

cover, insert a groove in the screw

cover into the bottom track of the

rain cap. (Figure 25)

Snap the groove in the top of the

screw cover into the top track of the

rain cap. (Figure 26).

Move accross screw cover, pressing

every few inches to snap into track

Repeat Steps 5 and 6 to install the

remaining side screw covers.

Loosen but do not remove the two

screws attaching the sweep to the

door, lower the sweep until the

ﬁ ns contact the door sill and then

re-tighten the screws. (Figure 27)

Lower the venting window so the

pre-drilled holes below the screen

are at a comfortable working height.

Align holes in window latch, insect

screen pull, and vent window, and

attach with two screws (Figure 28).

1.

2.

3.

4.

5.

6.

7.

8.

9.

10.

11.

LEFT HANDED - EXTERIOR VIEWS

BEFORE

AFTER

Figure 25

Figure 26

BEFORE

AFTER

Figure 25

Figure 26

Figure 24

Figure 23

Figure 23

Figure 24

2 - #8x1”

1/8”

1/8”

In this step, you will install the screw

covers over the mounting screws in the

rails and rain cap

Figure 27

In this step, you will adjust the sweep.

4

INTERIOR VIEW

NOTE: For additional seal against

rain, caulk above rain cap mounting

ﬂ ange.

In this step, attach the window latch..

Figure 28

17

10

11

Figure 27

4

INTERIOR VIEW

Figure 28

17

10

11

2 - #6 x 3/4”

1 2 3 4 5 6 7 8 9 10 11

Komentáře k této Příručce

Žádné komentáře